We will be closed from 27th of April - 11th of May. Please take this into account

Additional SFX Info.


What do you get with SFX?

Each font has fully configurable light, sound, and motion sensitivity settings. ​Choose from two different sound fonts.

Crimson or Viridian.

Button controlled Voice prompted menu for font selection and settings.

1. Boot up & menu settings

2. Choose from 1 of 8 Clash sensitivity settings

3. ​Choose from 1 of 8 swing sensitivity settings

4. Power on / Ignition
5. Power off / Retraction

6. Hum

Viridian also has Blaster Deflect effect when pressing the button

Crimson also has Blade Lockup effect when pressing the button

Each ForceSaber has a 2 watt speaker fitted inside the hilt.

Due to the power requirements these models run on a rechargeable Li-ion Battery.

What should you expect with these models?

When you purchase any model with sound you will receive as standard:-

1 x Hilt

1 x 32" blade

1 x USB recharging cable.

Every model with sound comes ready to use out of the packaging (UK Sales Only).

When you charge these sabers please only use a 5 Volt USB 1.0 or 2.0 USB port, anything greater could cause serious issues with the Li-ion battery. Allow no more than a 8 hour charge per time.

There is no Clash on Clash visual effects fitted to our models.​

WARNING! Do not use any charger with am output higher than 5 Volts and a maximum charging current of 1000 mA 

Additional INfo


Blade Specs:-

· Blade rating- Polycarbonate blade, Standard combat and sparing capable. (Not rated for extreme combat)
· Blade Tip - Slightly frosted pitted tip glued in place.
· Blade Base - Clear base cap glued in place.
· Blade Length - 32 Inches long.
· Blade Width - 24mm.
· Removable Blade - Untighten locking nut in rear of handle.
· Removable Blade - Interchangeable with other ForceSaber blades.
· No Clash On Clash Effects?

General Product Information:-

All ForceSabers are bespoke custom handmade to order. As this Saber is handmade there are unavoidably slight cosmetic scratches or imperfections on the handle or blade. Due to the construction of the internal blade housing there will be heavy scratch in this area but it will have no effect on the blade or use of the saber. The raw materials may also come with imperfections or marks. All switches are glued in place, the switch will not come lose but there can be residual glue around the switch. When being used these imperfections / points will have no effect or impact on the use of the item. 

Every ForceSaber uses a pre-coloured bespoke high powered LED. This LED powers the blade and gives the blade the required colour needed, these look amazing in low light (dusk) but in direct sunlight or bright day light it will not be 100% visible. We use a single powerful LED which has a high light output with very low power consumption.

All ForceSabers without SFX operate with a standard battery setup. Standard setup is a setup that uses regular 4 x AAA batteries to power your ForceSaber. (4 x AAA batteries are not supplied). We advise to use Alkaline batteries for best results.

If the individual listing states + SFX this means the model on this listing has sound effects installed. For models without this they will not have sound installed.


Do not leave the blade exposed to direct sunlight for prolonged periods of time as this will alter the translucent glue in the blade tip.

When not using the Forcesaber for long periods of time (days, weeks or longer) and used primarily for display, we strongly advise to remove the batteries to stop any damage caused by the batteries leaking inside the case. If this happens this will not be covered by Forcesabers.

When replacing the blade DO NOT overtighten the “Micro Screw”. If over tightened, this could lead to damage of the thread. (This is not covered under the returns policy)

Please Note:-

When purchasing this product you are confirming  you have read and agreed to all the information provided.